Description

Features and Specifications of Keysight (Agilent/HP) 71612B:

Introduction
This chapter contains general information about the HP 71612 Series System and is divided into the following sections:

• Safety Considerations :  General Safety Information, Safety Symbols
• Options :  Lists all the options available with your system.
• Accessories :  Supplied Lists the accessories supplied with your system.
• Serial Number Information :  Explains the Hewlett-Packard serial numbering system.
• Returning Instruments for Service :  Contains information on how to return an instrument to Hewlett-Packard for service.
• Precautions : Highlights electrostatic discharge procedures and accessories available. This section also contains information on lifting or carrying the HP 70843 and on cleaning the display.
• Updating Firmware :  Provides a procedure for updating the HP 70843 firmware.

Safety Considerations
This product is a Safety Class 1 instrument (provided with a protective earth terminal). The instrument and manual should be reviewed for safety markings and instructions before operation. Also read the Warnings page at the front of this manual.

Safety Information
The following general safety precautions must be observed during all phases of operation, service, and repair of this instrument. Failure to comply with these precautions or with specific warnings elsewhere in this manual violates safety standards of design, manufacture, and intended use of the instrument. Hewlett-Packard Company assumes no liability for the customer’s failure to comply with these requirements.
This is a Safety Class I instrument (provided with a protective earthing ground, incorporated in the powercord). The mains plug shall only be inserted in a socket outlet provided with a protective earth contact. Any interruption of the protective conductor inside or outside of the instrument is likely to make the instrument dangerous. Intentional interruption is prohibited.

Accessories Supplied
The accessories supplied with your system are listed below:

•  Two HP-MSIB cables.
•  Line power cable. (3 off when an HP 70001A mainframe is supplied.)
•  8 mm hex-ball driver.
•  4 off SMA to SMA test cables.
•  1 off N-SMA adapter.
•  5 off APC-3.5 mm connector savers.
•  2 off APC-3.5 mm male-female adapter.
•  7 off 50Ω SMA terminations.

Recommended Accessory List
The following items are not supplied with your instrument but are recommended accessories.

•  APC-3.5 mm cables.
•  APC-3.5 mm attenuators.
•  APC-3.5 mm 50Ω terminations.
•  Torque wrench for APC-3.5 mm.