Description
The Fluke 98-2 Scopemeter is the benchmark tester for everything that came after it. A two channel oscilloscope and built in multimeter provide a wealth of useful troubleshooting information. Powerful, portable and accuracy in a small hand held unit. The Fluke 97 ScopeMeter combines the capabilities of a dual-trace, digital storage oscilloscope with the versatility of a digital multimeter. This combination allows you to analyze and compare complex waveforms, read voltage levels, or simply measure resistance.
Feature
- Frequency Range/ Bandwith 50 MHz
- Max. Vertical Sensitivity 100 V/div
- Min. Vertical Sensitivity 1 mV/div
- Number of Channels 2 CH
- Record Length 512 pts.
- Sample Rate 25 MSa/s
- Type (D/A) Digital Hand Held
- Bandwidth: 50 MHz Dual Channel
- Sample Rate: 25 Megasamples/second
- Autoset: Automatically sets Voltage, Time & Trigger
- Multimeter Display: 3 2/3 Digits (> 3000 Counts)
- True RMS Volts: AC or AC+DC up to 600V (1700V Pk-Pk)
- Resistance: 30 ohm to 30 Mohm
- Diode Test: up to 2.8V
- Continuity Beeper
- Time/Division: 10 ns/div to 60 sec/div
- Volts/Division: 1 mV/div to 100 V/div
Specification
- Digital Delay or Pre-Trigger: By Number of Cycles, Events, Time or Zoom Mode
- Special Multimeter Modes: Min Max Average Record with Time Stamp, Relative (zero), dBm, dBV, dBW, Audio Watts, %Scale, Frequency, %Duty Cycle, Smoothing¿, Change Alert¿
- Oscilloscope Cursors: 15 Measurements, Display 5 Simultaneously
- Glitch Capture: >40 ns
- Waveform Processing: Average, Min Max, Record, Variable Persistence
- Waveform Memory: Store & Recall 8 Waveforms
- Set-up Memory: Store & Recall 10 Front Panel Set-Ups
- Waveform Mathematics: Add, Subtract, Multiply, Invert, Filter or Integrate Waveforms
- Signal Generator Output: Sine wave or Square wave
- Component Tester Output: voltage or current ramp
- Size: 2.4″ H x 5.1″ W x 10.2″ L
- Weight: 3.3 lbs
Reviews
There are no reviews yet.