Description

Speciication (spec):
Specifications represent warranted performance of a calibrated instrument that has been stored for a minimum of 2 hours within the operating temperature range of 0 to 55 °C, unless otherwise stated, and after a 45 minute warm-up period. The specifications include measurement uncertainty. Data represented in this document are specifications unless otherwise noted.

Typical (typ):
Typical (typ) describes additional product performance information that is not covered by the product warranty. It is performance beyond specifications that 80 percent of the units exhibit with a 95 percent confidence level at room temperature (approximately 25 °C). Typical performance does not include measurement uncertainty.

Nominal (nom) or measured (meas):
Nominal (nom) or measured (meas) describes a performance attribute that is by design or measured during the design phase for the purpose of communicating sampled, mean or average performance, such as the 50 ohm connector or amplitude drift vs. time. This data is not warranted and is measured at room temperature (approximately 25 °C).

Key Feature of N5183B:

Frequency range : 9 kHz to 40 GHz
Resolution : 0.001 Hz
Phase offset  : Adjustable in nominal 0.1° increments
Frequency switching speed 1 () = typical
SCPI mode (≤ 5 ms) ≤ 1.15 ms (≤ 750 μs) < 1.65 ms (1 ms)
List/step sweep mode (≤ 5 ms) ≤ 900 μs (≤ 600 μs) < 1.4 ms (850 μs)

1. Time from receipt of SCPI command or trigger signal to within 0.1 ppm of inal frequency or within 100 Hz, whichever is greater.
2. For export control purposes CW switching speed to within 0.05% of inal frequency is 190 us (meas).
3. For export control purposes CW switching speed to within 0.05% of inal frequency is > 400 us (nom) below 20 GHz and > 600 us (nom)
above 20 GHz.
4. Speciications apply when status register updates are off.